I do not know why this was necessary and why the Clover installation did not do this automatically.ġ: Copy the Clover kexts from the preparation folder onto the desktop and install them to /Library/Extensions using KextBeastĢ: Run Kext Utility to rebuild the kernel cacheģ: Reboot and verify everything boots up correctlyġ: Dump your DSDT using Clover and apply the following patches: I had to manually add it using the EFI shell from the USB install disk.īasically it was a matter of finding which partition the EFI folder on the hard disk was on and adding clover to the boot menu.įor me this was "bcfg boot add 04 fs2:\EFI\CLOVER\CLOVERX64.efi Clover" Note that it is important you set the USB disk as the highest boot priority since the laptop will restart a few times during installation.ġ: Once the installation is completed you should copy over the preparation folder to the desktop and eject the USB disk from your laptop.ģ: Copy over all of the files previously mentioned into their proper places (ist,SSDTs,kexts.)Ĥ: Reboot and it should start Clover from the hard diskĬLOVER DID NOT APPEAR IN THE BOOT MENU FOR ME: Plug the USB disk into the laptop along with a USB mouse, keeping in mind that the thunderbolt port is not hotpluggable.īoot into the installer and be VERY patient since it takes a fairly long time to complete. Kernel and Kext Patches: (Taken from config_ist)Ĭom.2CControllerįollow tutorial for serial number, UUID, ect… I found it best to make a folder with everything I needed in it for easier organization and copying later on.ġ: Do the usual createinstallmedia method to create your Mojave install disk and install Clover to it.Ģ: Copy over the clover kexts and HFSPlus.efi to their proper places.ģ: Modify and compile SSDT-RMNE.dsl to set a MAC address for the NULL ethernet driver and save it to /EFI/CLOVER/ACPI/patched/SSDT-RMNE.amlĥ: Using Clover Configurator, open config_HD615_620_630_640_650.plist and make the following changes: Mojave Install USB set to 1st boot priority Networking was provided by a USB-C ethernet adapter. There was only one value that needed to be patched by following the battery status guide, that seems a bit odd to me. Laptop wakes itself up while sleeping for some reason, I'll have to investigate that. Hotplug on Thunderbolt port, devices must be plugged in at boot Sleep (Even the fading in/out power button!)įingerprint scanner - Disconnected using usb-inject-all SSDT ![]() So lettuce pray I did all of this correctly and dive in! This is a work in progress so it's much less a guide than it is what I've done. Building a CustoMac Hackintosh: Buyer's Guide
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |